The MS GluePro is a very strong and quickly hardening hoof glue for attaching claw blocks underneath claws. In this way, the hoof with the inflammation / damage is relieved and thus can heal better.

MS GluePro is usable with all types of claw blocks, such as rubber, wood and polyurethane. Also suitable for use in both winter and summer, in all weather conditions.

• Exceptional adhesion
• No unpleasant smell
• Fast curing polyurethane adhesive
• 2-components
• 11 to 13 treatments per cartridge
• Hardening time: approx. 30 seconds

Use the MS GluePro only in combination with the designated dosage gun and mixing tips

• Step 1: Store the tube upright and hold the tube upright when opening
• Step 2: Open the tube or replace the mixer tip
• Step 3: Press the glue slowly until the mixer tip is filled halfway, with the tip pointing upward. The remaining air will move away from the tube
• Step 4: Slowly apply the glue in a fluid pump movement to the claw or the claw block
• Step 5: When you're done, please keep the tube with the tip down and relieve pressure from the gun to stop further flowing. After 10 seconds the gun can be put down flat. This prevents backflow of pre-mixed glue into the tube
• Step 6: At the next gluing, the tube does not contain air anymore and therefore you can proceed to step 3.

• Very little heat generation during curing
• The components are mixed in the correct proportion in the mixing tip
• The glue has a shelf life of at least one year (10 months after opening)
• Store at room temperature, do not allow to freeze

• Glueing of claw blocks on the claws of cattle
• For optimum results, the claw must be clean and dry
• A hot air gun or a hair dryer can be used to dry the claws
• Curing time: approx. 30 seconds. The claw block can fully bear weight again after 2 minutes